ServerLink KVM over IP Module Manuel d'utilisateur télécharger pdf (Page 70)

KVM over IP Module

70 / 99

Bandwidth limitation

The maximum network traffic generated through the IP-KVM ethernet device. Value in

Kbit/s.

Enable Telnet access

This enables the Telnet function.

Enable SSH access

This enables the SSH (Secure SHell) function.

Disable Setup Protocol

Enable this option to exclude the IP-KVM from the setup protocol. Setup protocol is a

proprietary layer-2 MAC-based protocol to allow some configuration software to detect

IP-KVM devices in the network, even without IP address, and then config network related

settings to IP-KVM..

LAN Interface Settings

The “Autodetect” will set the ethernet speed to the fastest possible value supported by both

endpoints of the link. For example, if you use a 10M/half duplex HUB, this speed will be

auto-selected. If this option does not work with some network device (HUB, switches, and

routers), you can set the Ethernet interface speed of IP-KVM manually to the values as

supported by the network device.

5.5.2 Dynamic DNS

Figure 5-19 Dynamic DNS

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 98 99

Pas de commentaire

ServerLink KVM over IP Module Manuel d'utilisateur Page 70